Jump to content
Sign in to follow this  
081 xtype

BOV installation

Recommended Posts

ey. i scored a cheap tenzo bov which is the same as a vee type turbosmart bov. the vee type turbosmart bov comes wit a wield on adaptor and my tenzo didnt. i have a series 5 rx7 which is stock as a rock which is including the rubber hose between my intercooler and turbo which the factor bov is situated. my question is do i need to replace this hose/piping to fit my tenzo bov or can i purches an adaptor or make a dodgy hose up 2 suit my tenzo bov. any help would be appriciated...thanks

Share this post


Link to post
Share on other sites

Ok I think I have worked out what you are asking... :P

 

This is how I used to run mine, +1 for the dodgey hose setup. Makes full boost and vents properly.

Good luck.

 

image5gf4.jpg

Share this post


Link to post
Share on other sites

I see what you've done. i should have made it simplier. thanks. i was after ideas of how to hook it up without paying too much

Share this post


Link to post
Share on other sites

2 hose clamps and a bit of radiator hose. v cheap ;)

Share this post


Link to post
Share on other sites

hks ssq nice i got one on mine but its mounted on the hose in a different possition

Share this post


Link to post
Share on other sites

hmmmm, mine looks a lot different to that ayye, my bov runs down low on the pipe from the trubo to the intercooler, im confused now

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×